Technical specifications:

• Solids content: 87% (SiO₂) with 99.9% purity

• Hardness: >9H

• Chemical resistance: Extreme, pH 0-13

• Durability: More than 5 years under real-world conditions

• Film thickness: approx. 3-4 microns.

• Drying time (flash time): 1-3 minutes (average 1-2 min)

• Coverage: 15 ml for small cars, 30 ml for large vehicles

• Water contact angle: 108-110°

• Operating temperatures: 4ºC to 38ºC

• Applicable surfaces: Paint, chrome, plastics, rims

• Shelf life: 12 months, use within 7 days of opening for best results

Precautions:

• Shake well before use.

• Avoid applying under direct sunlight.

• Use protection for skin, respiratory system and eyes.

• Always test on a small area to determine drying time.

• In cold climates, the time before removing will be longer (3-5 minutes).

• In warm climates, the time will be shorter (about 1 minute).

• Shelf life of 12 months; use within 7 days of opening.

Preparation:

Preparation is the key to success; the coating is excellent, but it doesn't replace good prior work.

1. Decontaminate the paint with Armour Detail Supply Decon Soap and Iron Remover , followed by deep cleaning with a clay bar or synthetic glove.

2. If there are marks or scratches, polish the paint to correct defects and achieve maximum shine.

3. Apply Armour Detail Supply Panel Prep to remove oils or polish residue. If you haven't polished, repeat this step twice to ensure cleanliness.

Application:

1. After preparation, apply 3 lines of product to the applicator; for subsequent applications, a small amount will suffice, as it goes a long way.

2. Apply Armour PRO panel by panel. First, create an "X" on the panel and outline the edges to distribute the product. Continue with small, overlapping circles, ensuring even coverage. Let it set for 1 to 5 minutes depending on temperature and humidity (usually 2-3 minutes). Look for a slight mist before removing.

3. Using small circular motions, remove the excess with a short microfiber towel (pearl-like). The first pass will have some grip, but it should come off easily. If it spreads, it needs more time; if it's difficult to remove, less time. Switch to a softer towel for the final touch. Check for streaks or smudges.

4. Change the applicator side for a clean one every 3-4 panels, as the coating is highly concentrated and hardens quickly.

5. Change the side of the removal towels every two panels. You may need two towels for the first pass.

If you wish to apply a layer of Armour Quartz Coating over Armour PRO, wait between 1 and 2 hours.

Maintenance:

Allow to cure for at least 12 hours. After 4 hours, you can use Armour Detail Supply AMPLIFY or Ceramic Spray Sealant to protect the coating during the initial curing. After 12 hours, the vehicle can be driven and get wet, but avoid washing it or exposing it to chemicals for 7 days.